Lyntec RPCM Manual do Utilizador descarregar pdf (Página 10)

139-0498-0110

Chapter Four--Wiring

Emergency Shutdown Wiring:

To connect your  re alarm or emergency management system

to the RPCM, follow these steps.

1. From the  re alarm unit or latching Emergency Shuto

switch, wire the common to pin 1 and the open circuit to

pin 2 (Figure 4-1).

2. When the Normally Open contacts are closed, all breakers

that have been selected for E. Shuto cycle to OFF.

3. When the contacts are released, the status indicator should

extinguish and, if recovery is checked, all breakers that

were ON when E. Shuto was activated should return to the

ON state.

See Chapter 5 to con gure the software for emergency

shutdown.

Figure 4-1: Override connector

Emergency Lighting Wiring:

To connect your emergency lighting system to the RPCM,

follow these steps.

1. From the  re alarm unit or latching Emergency Lighting

switch, wire the common to pin 1 and the open circuit to

pin 3 (Figure 4-1).

2. When the Normally Open contacts are closed, all breakers

that have been selected for E. Lighting cycle to ON.

3. When the contacts are released, the status indicator should

extinguish and, if recovery is checked, all breakers should

return to their previous state.

See Chapter 5 to con gure the software for emergency

lighting.

To operate Emergency Shutdown and Emergency Lighting

simultaneously, tie pins 2 and 3 together.

Pin 1Pin 2

Pin 3

OVERRIDE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 36 37

Sem comentários

Lyntec RPCM Manual do Utilizador Página 10